Epson ET-2760 Installation Guide PDF Download

About Epson ET-2760 Installation Guide

This document describes to you about how to unpacking the printer, printer installation and setup the printer.

Installation Guide Table of Content

1. How to unpacking the printer
• Remove all protective materials from the product
• Lift up the scanner unit. Remove all protective materials from inside the product.
2. How to fill ink tanks
1. Open the ink tank cover, then open the cap for the black ink tank.
2. Unpack the black (BK) ink bottle. Hold the ink bottle upright and slowly turn the bottle cap to remove it.
3. Insert the ink bottle into the filling port
4. Wait for the ink to fill the tank. Do not squeeze the bottle. Ink flows into the tank and stops automatically when the ink is filled to the upper line.
5. When the ink tank is full, remove the ink bottle and replace the bottle cap. Place the remaining ink aside; you will need it later
6. Close the ink tank cap.
7. Repeat the previous steps for the other colors
8. Close the ink tank cover and then the scanner unit.
9. Connect the power cord to the back of the product and to a power cord.
10. Raise the control panel, then press the power button to turn on the printer.
11. Press up or down button to select your language on the LCD screen, then press the OK button
12. When the message to see the Start Here sheet appears on the LCD screen, press the OK button. On the next screen, press and hold the help button for 3 seconds.
13. When the message to start initialization appears on the LCD screen, press the start button to start charging the ink. Ink charging takes approximately 10 minutes. A message appears when ink charging is complete. Press the OK button to continue.
14. To complete filling the ink tanks, repeat steps 1 through 7 using the remaining ink in the bottles.
15. Close the ink tank cover and scanner unit.
16. Select Maintenance > Reset Ink Levels, then follow the on-screen instructions to reset the ink levels.
17. Follow the on-screen instructions to adjust the print quality. Press the OK button to continue.
3. How to Load papers
• Make sure the product is not charging ink. Then flip the feeder guard forward, raise the paper support, and tilt it backwards slightly.
• Slide the edge guides all the way out
• Load paper, glossy or printable side up and short edge first, in the middle of the rear paper feed slot.
• Slide the edge guide against the paper, but not too tightly.
• Pull out the output tray
• Select the paper settings on the product’s control panel.
4. Install driver and software
5. Problem and Question

Download Epson ET-2760 Installation Guide

For detailed steps about how to unpacking Epson ET-2760, Installing, and setup, please download the document from the link bellow

• Title : Start Here - ET-2760
• Document type : PDF
• Pages : 2 pages
• Language : English
• File Size : 1.19 MB

Epson ET-2760 Manuals Download