Epson ET-2720 Installation Guide PDF Download

About ET-2720 Installation Guide

This document describes about : Instructions before using the printer, step by step how to install the new printer.

Installation Guide for ET-2720

IMPORTANT: Before using this product, make sure you read these instructions and the safety instructions in the User’s Guide.

Step 1 Unpack

Note: Do not open the ink bottles until you are ready to fill the ink tanks. The ink bottles are vacuum packed to maintain reliability. Remove all protective materials from the product. Do not turn on the printer yet

Step 2 Fill the ink tanks

Warning: Keep the ink bottles out of the reach of children and do not drink the ink.

Caution: This product requires careful handling of ink. If ink spills, wipe it off immediately with a damp towel to avoid permanent stains. If ink gets on your clothes or belongings, it may not come off.

Note:

Epson cannot guarantee the quality or reliability of non-genuine ink.
Use the ink bottles included with the printer to set up the product. Part of the ink will be used to charge the print head. These bottles may print fewer pages compared with replacement ink bottles.

Open the ink tank cover and the cap for the black ink tank.
Note: Refer to the color-coded sticker on the ink tank unit to identify the color of each tank.
Unpack the black (BK) ink bottle. Hold the ink bottle upright and slowly turn the bottle cap to remove it. Caution: Do not shake or squeeze the ink bottle. Do not touch the top of the ink bottle after its cap is removed.
Place the top of the ink bottle on the filling port, then slowly stand the bottle upright to insert it, as shown. Note: Do not force the bottles into position; they are keyed for each color.
Wait for the ink to fill the tank. Do not squeeze the bottle. Ink flows into the tank and stops automatically when the ink tank is filled to the upper line. If ink does not flow from the bottle, lift and reinsert the bottle.
When the ink tank is full, remove the ink bottle and securely close it with the bottle cap. Do not leave the ink bottle inserted; otherwise the bottle may be damaged or ink may leak. If any ink remains in the bottle, store the bottle upright and top off the ink tank after completing initial setup.
Close the black ink tank cap.
Repeat the previous steps for the other colors.
Close the ink tank cover.
Connect the power cord to the back of the product and to an electrical outlet. Do not connect to your computer yet
Raise the control panel, then press power button to turn on the product. The power light will flashes
Select your language. You can change this setting later using the product control panel.
When instructed to see the start here sheet, press and hold the help button for 5 seconds
Press the Start button to start ink charging. Ink charging takes about 10 minutes. When the power light stop flashing, ink charging is complete, you can top off the ink tanks with any remaining ink. Do not unplug or turn off the printer or open the inner cover while product is charging or you will waste ink.
Press the OK button to proceed with initial setup
Follow the on-screen instructions to adjust the print quality of your printer

Step 3 Load Paper

See the ET-2720 User’s Guide for information about loading capacity, available paper types and sizes, and loading envelopes.

Step 4 Install printer driver and Software

To download the printer driver and software you can visit Epson ET-2720 Driver and Software Download

For more detailed step, you can read the Installation guide PDF files bellows

Read the installation guide PDF